Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SPIRAL CABLE › 2015.08–2016.09
RM19Y0E _58 Vehicle Interior _003010 SUPPLEMENTAL RESTRAINT SYSTEMS _0015209 SPIRAL CABLE A

SUPPLEMENTAL RESTRAINT SYSTEMS  SPIRAL CABLE  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


Hide 2.PLACE FRONT WHEELS FACING STRAIGHT AHEAD

Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 45100 4.REMOVE STEERING WHEEL ASSEMBLY

Hide 45287 5.REMOVE LOWER STEERING COLUMN COVER

Hide 45286B 6.REMOVE UPPER STEERING COLUMN COVER

Hide 45107 7.REMOVE HORN BUTTON WIRE SUB-ASSEMBLY (w/o Steering Pad Switch)

a.

Disconnect the horn button wire sub-assembly from the spiral cable sub-assembly.


Hide 84306 8.REMOVE SPIRAL CABLE SUB-ASSEMBLY

a.
B412677C01
0.552,3.208 0.74,3.104 true 2.375,3.24 2.563,3.135 true 0.365,3.146 0.677,3.344 0.313,0.198 10 false *1 2.198,3.156 2.51,3.354 0.313,0.198 10 false *2
*1 Lock Slider
*2 Airbag Connector
(Yellow Colored)


Pull the lock slider in the direction indicated by the arrow to release the connector lock and disconnect the airbag connector (yellow colored) from the spiral cable sub-assembly.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.



b.

Disconnect the connector from the spiral cable sub-assembly.


c.
B412678

Disengage the 3 claws to remove the spiral cable sub-assembly.