Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CENTER AIRBAG SENSOR ASSEMBLY › from 2015.08
RM19Y0E _58 Vehicle Interior _003010 SUPPLEMENTAL RESTRAINT SYSTEMS _0015211 CENTER AIRBAG SENSOR ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  CENTER AIRBAG SENSOR ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

PROCEDURE

Hide 89237A 1.INSTALL ECU UNIT BRACKET

a.

Install the ECU unit bracket with the 3 bolts.

Torque:
8.4 N*m (86 kgf*cm, 74 in.*lbf)


Hide 89170A 2.INSTALL AIRBAG ECU ASSEMBLY

a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS.



c.
B412685C01
1.052,1.865 1.708,1.167 true 0.885,1.802 1.198,2 0.313,0.198 10 false *1
*1 Waterproof Sheet


Install the airbag ECU assembly with the 3 nuts.

Torque:
8.4 N*m (86 kgf*cm, 74 in.*lbf)

NOTICE:
·

If the airbag ECU assembly has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.

·

When installing the airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

·

When the ignition switch is first turned to ON after the airbag ECU assembly has been replaced, make sure that no one is in the vehicle.




d.

Connect the 2 airbag connectors to the airbag ECU assembly.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.



e.

Engage the 3 clamps.


f.

Check that the airbag ECU assembly is not loose.


g.

Check that the waterproof sheet is not peeled off.


Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Torque:
6.4 N*m (65 kgf*cm, 57 in.*lbf)