This circuit operates the spool valve by means of the duty signal from the ECM so as to switch the oil passages to the advanced side or retarded side to activate the VVT controller (camshaft timing sprocket assembly). In this way, optimum valve timing is maintained.
When the engine is stopped, the camshaft timing oil control valve is set to the most retarded position.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| P0010 | IN. Oil Control Valve System Open/Short Malfuction | Open or short in camshaft timing oil control valve assembly (for intake camshaft) circuit for 1 seconds or more
(1 trip detection logic) |
·
Open or short in camshaft timing oil control valve assembly (for intake camshaft) circuit ·
Camshaft timing oil control valve assembly (for intake camshaft) ·
ECM |
Comes on | DTC stored |
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
Turn the ignition switch off and wait for at least 30 seconds.
Turn the ignition switch to ON and turn the GTS on.
Wait 10 seconds or more.
Enter the following menus: Powertrain / EFI / Trouble Codes.
Read the pending DTCs.
If a pending DTC is output, the system is malfunctioning.
If a pending DTC is not output, the system is normal.
Read freeze frame data using the GTS. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Clear DTCs after recording the freeze frame data and DTCs.
Start the engine.
Allow the engine to idle and check for DTCs.
Enter the following menus: Powertrain / EFI / Trouble Codes.
Read DTCs.
| Result | Proceed to |
|---|---|
| DTC P0010 is output | A |
| DTC is not output | B |
A
B
Inspect the camshaft timing oil control valve assembly (for intake camshaft).
Click hereEngine / Hybrid System>1NR-VE ENGINE CONTROL>CAMSHAFT OIL CONTROL VALVE>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the camshaft timing oil control valve assembly (for intake camshaft) connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connections | Condition | Specified Conditions |
|---|---|---|
| C21-1 - C50-10 (OCV+) | Always | Below 1 Ω |
| C21-2 - C50-11 (OCV-) | Always | Below 1 Ω |
| C21-1 or C50-10 (OCV+) - Body ground | Always | 10 kΩ or higher |
| C21-2 or C50-11 (OCV-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG