Home › Engine / Hybrid System › 1NR-VE ENGINE CONTROL › CRANKSHAFT POSITION SENSOR › from 2015.08
RM19Y0E _51 Engine / Hybrid System _042271 1NR-VE ENGINE CONTROL _0196157 CRANKSHAFT POSITION SENSOR A

1NR-VE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11301K 1.INSTALL CRANK POSITION SENSOR

a.
A198002

Apply a light coat of engine oil to the O-ring.

NOTICE:

If reusing the crank position sensor, be sure to inspect the O-ring.



b.

Install the crank position sensor with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:
·

If a component has been dropped or subjected to a strong impact, replace it.

·

Make sure that the O-ring is not damaged or does not jump out of position during installation.




c.

Connect the crank position sensor connector.


Hide 17750A 2.INSTALL AIR CLEANER INLET ASSEMBLY