89465
1.INSTALL OXYGEN SENSOR (w/o Air Fuel Ratio Sensor)
| *a | Torque Wrench Fulcrum Length |
Using SST, install the oxygen sensor to the exhaust manifold converter sub-assembly.
If a component has been dropped or subjected to a strong impact, replace it.
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)): 29 N*m (296 kgf*cm, 21 ft.*lbf)
Engage the 2 harness clamps and connect the oxygen sensor wire to the radiator pipe sub-assembly.
Connect the oxygen sensor connector.
89465A
2.INSTALL NO. 2 OXYGEN SENSOR (w/ Air Fuel Ratio Sensor)
| *a | Torque Wrench Fulcrum Length |
Using SST, install the No. 2 oxygen sensor to the front exhaust pipe assembly.
If a component has been dropped or subjected to a strong impact, replace it.
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)): 29 N*m (296 kgf*cm, 21 ft.*lbf)
Engage the 2 harness clamps and connect the No. 2 oxygen sensor connector.
3.INSPECT FOR EXHAUST GAS LEAK
51443
4.INSTALL NO. 2 ENGINE UNDER COVER (w/ Air Fuel Ratio Sensor)