Home › Engine / Hybrid System › 2NR-VE ENGINE MECHANICAL › FRONT CRANKSHAFT OIL SEAL › from 2015.08
RM19Y0E _51 Engine / Hybrid System _042274 2NR-VE ENGINE MECHANICAL _0196191 FRONT CRANKSHAFT OIL SEAL A

2NR-VE ENGINE MECHANICAL  FRONT CRANKSHAFT OIL SEAL  REMOVAL  


PROCEDURE

Hide 51441 1.REMOVE NO. 1 ENGINE UNDER COVER

Hide 16361A 2.REMOVE FAN AND GENERATOR V BELT

Hide 13471 3.REMOVE CRANKSHAFT PULLEY

a.
A360083C01
2.281,1.885 2.74,1.875 false 2.469,2 2.781,2.156 0.313,0.156 10 false *a 2.792,1.792 3.25,1.99 0.458,0.198 10 false SST
*a Hold
V100135

Turn


Using SST, remove the crankshaft pulley bolt.

SST
09960-10010  (09962-01000, 09963-01000)

NOTICE:

Never turn the crankshaft pulley counterclockwise (when viewed from the front of the engine).



b.

Remove the crankshaft pulley from the crankshaft.


Hide 11302A 4.REMOVE TIMING CHAIN COVER OIL SEAL

a.
A361371C01
1.26,1.219 1.552,1.625 true 2.292,1.802 2.75,1.948 2.75,1.948 3.156,1.813 false 0.083,2 0.396,2.156 0.313,0.156 10 false *a 2.698,1.979 3.01,2.135 0.313,0.156 10 false *b 1.563,1.625 1.802,1.844 0.24,0.219 10 true *c
*a Pry
*b Cut Position
*c Protective Tape


Using a knife, cut off the timing chain cover oil seal lip.


b.

Using a screwdriver with its tip wrapped with tape, pry out the timing chain cover oil seal.

NOTICE:

After removing, check the crankshaft and timing chain cover sub-assembly for damage. If damaged, smooth the surface with 400-grit sandpaper.