Home › Engine / Hybrid System › 2NR-VE FUEL › FUEL INJECTOR › from 2015.08
RM19Y0E _51 Engine / Hybrid System _042276 2NR-VE FUEL _0196204 FUEL INJECTOR A

2NR-VE FUEL  FUEL INJECTOR  REMOVAL  


PROCEDURE

Hide 1. DISCHARGE FUEL SYSTEM PRESSURE

Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 17700 3.REMOVE AIR CLEANER ASSEMBLY

Hide 23842A 4.REMOVE EFI FUEL PIPE CLAMP

A359803

a.

Remove the EFI fuel pipe clamp.


Hide 23901 5.DISCONNECT FUEL TUBE SUB-ASSEMBLY

A359804

a.

Pinch the retainer of the fuel tube connector, and then pull the fuel tube connector off of the fuel delivery pipe.


Hide 23814B 6.REMOVE FUEL DELIVERY PIPE

a.

Make sure that there are no deposits such as sand or grit near the fuel injector assembly, and if there are any deposits, clean them away.

NOTICE:

Do not allow foreign matter to enter any other components.



b.
A359805

Disconnect the 4 fuel injector assembly connectors.


c.
A359806

Remove the 2 bolts and fuel delivery pipe with the 4 fuel injector assemblies.

NOTICE:

Do not allow foreign matter to enter the cylinder head sub-assembly.



Hide 23807V 7.REMOVE NO. 1 DELIVERY PIPE SPACER

a.
A359807

Remove the 2 No. 1 delivery spacers from the cylinder head sub-assembly.


Hide 23291 8.REMOVE INJECTOR VIBRATION INSULATOR

A359809

a.

Remove the 4 injector vibration insulators.


Hide 23250 9.REMOVE FUEL INJECTOR ASSEMBLY

a.
A296026

Pull the 4 fuel injector assemblies out of the fuel delivery pipe.

NOTICE:

Do not allow foreign matter to enter the fuel delivery pipe.



b.

Remove the O-ring from each fuel injector assembly.


c.
A200115

For reinstallation, attach a tag or label with the corresponding cylinder number to each fuel injector assembly shaft.

NOTICE:

Protect the fuel injector assemblies by covering them with plastic bags.