Home › Engine / Hybrid System › 2NR-VE FUEL › FUEL TANK › from 2015.08
RM19Y0E _51 Engine / Hybrid System _042276 2NR-VE FUEL _0196207 FUEL TANK A

2NR-VE FUEL  FUEL TANK  REMOVAL  


PROCEDURE

Hide 1. DISCHARGE FUEL SYSTEM PRESSURE

Hide 2.DRAIN FUEL

a.
A360462

Remove the drain plug, and drain the fuel into a container.


b.

Clean the drain plug and install it with a new gasket.

Torque:
6.5 N*m (66 kgf*cm, 58 in.*lbf)


Hide 37110 3.REMOVE PROPELLER SHAFT ASSEMBLY

Hide 77259C 4.DISCONNECT FUEL HOSE

a.
A142185C01
1.625,1.708 1.885,1.448 false 0.969,1.729 1.229,1.469 false 0.844,1.76 1.156,1.917 0.313,0.156 10 false *1 1.5,1.74 1.813,1.896 0.313,0.156 10 false *2
*1 Fuel Tank To Canister Tube
*2 Fuel Hose


Loosen the hose clamp to disconnect the fuel hose from the fuel tank to canister tube.


Hide 77204A 5.DISCONNECT FUEL TANK RETURN TUBE

a.
A261574C05
2.49,1.708 2.031,2.042 true 2.5,3.24 2.594,2.885 false 1.833,3.313 1.708,2.854 false 2.906,4.104 3.01,3.729 false 0.938,3.375 0.854,3.125 false 1.688,3.781 1.771,4.115 1.771,4.115 1.844,3.781 true 0.979,1.167 1.063,0.885 false 2.521,2.677 2.708,2.833 0.188,0.156 10 false *1 2.802,4.156 2.99,4.313 0.188,0.156 10 false *5 1.698,4.156 1.885,4.313 0.188,0.156 10 false *4 1.625,2.656 1.813,2.813 0.188,0.156 10 false *2 0.75,2.927 0.938,3.083 0.188,0.156 10 false *3 1.844,2.021 2.031,2.177 0.188,0.156 10 false *1 0.865,1.229 1.052,1.385 0.188,0.156 10 false *5
*1 Retainer
*2 Fuel Tube Connector
*3 Nylon Tube
*4 O-ring
*5 Fuel Main Tube
V100135

Pinch
V100136

Pull out


Disengage the 2 claws and push down the retainer as illustrated.


b.

Pull the fuel tank return tube out of the fuel main tube.

NOTICE:
·

Remove any dirt and foreign matter from the fuel tube connector.

·

Do not allow any scratches or foreign matter on the parts when disconnecting them as the fuel tube connector has O-rings that seal the fuel main tube.

·

Perform this work by hand. Do not use any tools.

·

Do not forcibly bend, twist or turn the nylon tube.

·

Protect the disconnected parts by covering them with a plastic bag after disconnecting the fuel tube connector.

·

As some pressure remains in the fuel line, use a piece of cloth to prevent gasoline from splashing out.

·

If the fuel tube connector and fuel main tube are stuck, pinch the fuel main tube and push and pull the fuel tube connector to release them.




Hide 77213B 6.DISCONNECT FUEL TANK TO FILLER PIPE HOSE

a.
A364941

Loosen the hose clamp and disconnect the fuel tank to filler pipe hose from the fuel tank inlet pipe sub-assembly.


Hide 77269A 7.DISCONNECT FUEL TANK BREATHER HOSE

a.
A364942

Loosen the hose clamp and disconnect the fuel tank breather hose from the fuel tank inlet pipe sub-assembly.


Hide 77100 8.REMOVE FUEL TANK ASSEMBLY

a.

Hold the fuel tank assembly using a transmission jack.


b.
A359799

Remove the 4 bolts.


c.

Operate the transmission jack, then remove the fuel tank assembly from the vehicle.

NOTICE:

Make sure that the fuel tank assembly does not fall.



Hide 77631A 9.REMOVE CENTER LOWER FUEL TANK PROTECTOR

a.
A142197

Remove the 3 bolts and center lower fuel tank protector.


Hide 87268T 10.REMOVE NO. 1 PROTECTOR

a.
A322183

Remove the 2 nuts and No. 1 protector.


Hide 11.DISCONNECT FUEL PUMP HARNESS

a.
A353549

Disconnect the 2 clamps and fuel pump harness.


Hide 77020A 12.REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY

Hide 23300J 13.REMOVE FUEL FILTER ASSEMBLY

A325607

a.

Remove the 2 bolts and fuel filter assembly.


Hide 77285D 14.REMOVE NO. 1 FUEL TUBE CLAMP

a.
A359667

Disengage the 2 claws to remove the No. 1 fuel tube clamp from the fuel tank assembly.


Hide 77286D 15.REMOVE NO. 2 FUEL TUBE CLAMP

a.
A322182

Disengage the guide to remove the No. 2 fuel tube clamp from the fuel tank assembly as shown in the illustration.


Hide 77213B 16.REMOVE FUEL TANK TO FILLER PIPE HOSE

A142194

a.

Loosen the hose clamp and remove the fuel tank to filler pipe hose from the fuel tank assembly.


Hide 77269A 17.REMOVE FUEL TANK BREATHER HOSE

A142195

a.

Loosen the hose clamp and disconnect the fuel tank breather hose from the fuel tank assembly.


Hide 77108B 18.REMOVE FUEL TANK FILLER CHECK VALVE SUB-ASSEMBLY

A142196

a.

Remove the fuel tank filler check valve sub-assembly from the fuel tank assembly.


Hide 77259G 19.REMOVE FUEL HOSE CLIP

a.
A359668

Disengage the 4 claws and remove the fuel hose clip from the fuel tank assembly.


Hide 77013 20.REMOVE NO. 2 FUEL TANK BREATHER TUBE SUB-ASSEMBLY

a.
A325608

Detach the No. 2 fuel tank breather tube sub-assembly from the fuel tank assembly.


b.
A142200

Remove the 4 bolts and No. 2 fuel tank breather tube sub-assembly.


Hide 77380 21.REMOVE FUEL CUT OFF VALVE ASSEMBLY

a.
A142201

Remove the fuel cut off valve assembly from the fuel tank assembly.


Hide 77141B 22.REMOVE NO. 1 FUEL TANK FLANGE REINFORCEMENT

A368675

a.

Remove the 4 No. 1 fuel tank flange reinforcements from the fuel tank assembly.


Hide 77277R 23.REMOVE FUEL TANK FILLER PIPE PROTECTOR

a.
A360463

Remove the 3 clips and the fuel tank filler pipe protector.


Hide 77201 24.REMOVE FUEL TANK INLET PIPE SUB-ASSEMBLY

A364923

a.

Remove the fuel tank cap assembly.


b.

Remove the 2 bolts, then pull the fuel tank inlet pipe sub-assembly out of the fuel tank filler pipe shield.