Home › Engine / Hybrid System › 1NR-VE COOLING › COOLING FAN MOTOR › from 2015.08
RM19Y0E _51 Engine / Hybrid System _042281 1NR-VE COOLING _0196231 COOLING FAN MOTOR G

1NR-VE COOLING  COOLING FAN MOTOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 16363 1.INSPECT COOLING FAN MOTOR

a.

Remove the air cleaner inlet assembly.

Click hereEngine / Hybrid System>1NR-VE ENGINE MECHANICAL>ENGINE ASSEMBLY>REMOVAL


b.
A186191C03
2.385,0.99 1.938,1.583 true 1.115,1 1.552,1.583 true 0.115,0.104 0.563,0.5 0.448,0.396 10 *a 0.896,0.76 1.302,1.073 0.406,0.313 10 (+) 2.427,0.76 2.896,1.177 0.469,0.417 10 (-)
*a Component without harness connected
(Cooling Fan Motor)


Check that the motor operates smoothly when battery voltage is applied to the cooling fan motor connector.


c.

Connect the 400 A probe of an ammeter to terminal 2 (+) of the cooling fan motor.


d.

Measure the current while the motor is operating.

Standard Current:
w/ Cooling Fan Resistor:
Tester Connection Condition Specified Condition
1 (-) - 2 (+) 20°C (68°F) 10.0 to 15.0 A


Standard Current:
w/o Cooling Fan Resistor:
Tester Connection Condition Specified Condition
1 (-) - 2 (+) 20°C (68°F) 6.4 to 9.4 A


If the result is not as specified, replace the cooling fan motor.


e.

Install the air cleaner inlet assembly.

Click hereEngine / Hybrid System>1NR-VE ENGINE MECHANICAL>ENGINE ASSEMBLY>INSTALLATION