1.INSPECT COOLING FAN RESISTOR
Remove the air cleaner inlet assembly.
Click hereEngine / Hybrid System>2NR-VE ENGINE MECHANICAL>ENGINE ASSEMBLY>REMOVAL
Disconnect the cable from the negative battery terminal.
Remove the battery.
Click hereEngine / Hybrid System>2NR-VE ENGINE MECHANICAL>ENGINE ASSEMBLY>REMOVAL
Disconnect the cooling fan resistor connector.
| *a | Component without harness connected
(Cooling Fan Resistor) |
Measure the resistance of the cooling fan resistor.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1(-) - 2(+) | 20°C (68°F) | 1.17 Ω to 1.43 Ω |
If the resistance is not as specified, replace the cooling fan resistor.
Connect the cooling fan resistor connector.
Install the battery.
Click hereEngine / Hybrid System>2NR-VE ENGINE MECHANICAL>ENGINE ASSEMBLY>INSTALLATION
Connect the cable to the negative battery terminal.
Install the air cleaner inlet assembly.
Click hereEngine / Hybrid System>2NR-VE ENGINE MECHANICAL>ENGINE ASSEMBLY>INSTALLATION