28100
1.INSTALL STARTER ASSEMBLY
Do not let a tool come into contact with the film seal on the starter commutator end frame assembly.
Install the starter assembly with the 2 bolts.
Connect the starter assembly connector.
Connect the engine wire with the nut.
11363A
2.INSTALL FLYWHEEL HOUSING SIDE COVER
Insert the protruding portion of the flywheel housing side cover into the end of the cylinder block sub-assembly and while pushing it along the cylinder block sub-assembly, engage the claw with the cylinder block sub-assembly.
Make sure that the claw makes a click sound, indicating a tight fit.
Replace the flywheel housing side cover with a new one if it does not engage securely or is deformed.
51022
3.INSTALL REAR ENGINE SUPPORT MEMBER SUB-ASSEMBLY
Operate the transmission jack and install the rear engine support member sub-assembly with the 4 bolts.
17451
4.INSTALL EXHAUST PIPE GASKET
17410
5.SET FRONT EXHAUST PIPE ASSEMBLY
58151A
6.INSTALL NO. 1 FLOOR HEAT INSULATOR
17410
7.INSTALL FRONT EXHAUST PIPE ASSEMBLY
37110
8.INSTALL PROPELLER SHAFT ASSEMBLY
9.ADD AUTOMATIC TRANSMISSION FLUID
10.INSPECT AUTOMATIC TRANSMISSION FLUID
11.INSPECT FOR AUTOMATIC TRANSMISSION FLUID OIL LEAK
11452
12.INSTALL OIL LEVEL DIPSTICK GUIDE
13.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL