If a door glass or a power window regulator motor assembly does not operate smoothly, the jam protection function may be triggered automatically, resulting in the auto up function being unable to fully close the window.
This symptom may occur only in the driver side window.
If the battery has been disconnected, the connector has been disconnected from the power window regulator master switch assembly, or POWER B fuse in main body ECU (fuse block assembly) has been removed, initialize the power window control system.
If the power window regulator motor assembly RH*1 or LH*2 (for front side) has been replaced, initialize the power window control system.
If the power window regulator motor assembly RH*1 or LH*2 (for front side) has been removed and installed, or if the power window regulator motor assembly RH*1 or LH*2 (for front side) was reused when the door glass or door glass run was replaced, initialize the power window control system.
After a door glass or door glass run has been replaced, the jam protection function may operate unexpectedly when the auto up feature is used due to detection of a door glass moving speed value different from the learned value. In this case, initialize the power window control system.
After a door glass or a door glass run has been replaced, the jam protection function may operate unexpectedly when the auto up function is used. In such cases, the auto up function can be resumed by repeating the following operation at least 5 times:
Close the power window by fully pulling up the power window regulator master switch assembly and holding it in the auto up position.
Open the power window by fully pushing down the power window regulator master switch assembly.
*1: for RHD
*2: for LHD
Initialize the power window regulator master switch assembly.
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION
| Proceed to |
|---|
| NEXT |
NEXT
Check that the driver side power window moves when the auto up and down function of the power window regulator master switch assembly is operated.
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK
Driver side power window auto up and down function is normal.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the front door window regulator sub-assembly RH*1 or LH*2.
Install the window glass onto the front door glass run RH*1 or LH*2.
Check if the front door window regulator sub-assembly RH*1 or LH*2 operates smoothly.
*1:for RHD
*2:for LHD
Check that the window glass slides smoothly when sliding it up by hand.
Perform initialization again.
Ensure the following:
The window glass fits with the glass run without improper contact or deformation.
Foreign objects are not caught in the glass run.
Door window glass slides smoothly.
| Proceed to |
|---|
| OK |
| NG |
OK
NG