Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM › from 2015.08
RM19Y0E _59 Vehicle Exterior _003016 WINDOW / GLASS _0015247 POWER WINDOW CONTROL SYSTEM J

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM  Jam Protection Function does not Operate  


DESCRIPTION

The jam protection function operates within a specified range during the manual up or auto up operation.

HINT:

This symptom may occur only in the driver side window.


CAUTION / NOTICE / HINT

NOTICE:
·

If the battery has been disconnected, the connector has been disconnected from the power window regulator master switch assembly, or POWER B fuse in main body ECU (fuse block assembly) has been removed, initialize the power window control system.

·

If the power window regulator motor assembly RH*1 or LH*2 (for front side) has been replaced, initialize the power window control system.

·

If the power window regulator motor assembly RH*1 or LH*2 (for front side) has been removed and installed, or if the power window regulator motor assembly RH*1 or LH*2 (for front side) was reused when the door glass or door glass run was replaced, initialize the power window control system.

·

After a door glass or door glass run has been replaced, the jam protection function may operate unexpectedly when the auto up feature is used due to detection of a door glass moving speed value different from the learned value. In this case, initialize the power window control system.

·

After a door glass or a door glass run has been replaced, the jam protection function may operate unexpectedly when the auto up function is used. In such cases, the auto up function can be resumed by repeating the following operation at least 5 times:

1.

Close the power window by fully pulling up the power window regulator master switch assembly and holding it in the auto up position.

2.

Open the power window by fully pushing down the power window regulator master switch assembly.




*1: for RHD

*2: for LHD


PROCEDURE

1.PERFORM INITIALIZATION
a.

Initialize the power window regulator master switch assembly.

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION

Result:
Proceed to
NEXT




NEXT

2.CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP/DOWN FUNCTION)
2.CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP/DOWN FUNCTION)
a.

Check if the power window auto up and down function operates normally.

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK

OK:

Auto up and down function is normal.


Result:
Proceed to
OK
NG




OK

3.CHECK JAM PROTECTION FUNCTION OPERATING RANGE

NG

REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY

3.CHECK JAM PROTECTION FUNCTION OPERATING RANGE
a.

Check if the jam protection function operates normally for the driver side power window.

HINT:

The jam protection function will not operate within 4 mm (0.157 in.) of the fully closed position.


OK:

Jam protection function operates normally.


Result:
Proceed to
OK
NG




OK

END (PROBLEM DUE TO INITIALIZATION FAILURE)

NG

REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY