The main body ECU (fuse block assembly) controls the operation of the TAIL relay.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Connect the GTS or Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the GTS or Techstream on.
Enter the following menus: Body Electrical / Body / Active Test.
According to the display on the GTS or Techstream, perform the Active Test.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Tail lamp | Taillight Relay | ON/OFF | - |
Taillight relay operates (Taillights illuminate).
| Result | Proceed to |
|---|---|
| OK (for LHD) | A |
| OK (for RHD) | B |
| NG | C |
A
B
C