31321
1.INSTALL CLUTCH PEDAL PAD
31301B
2.INSTALL NO. 1 CLUTCH PEDAL CUSHION
Install the No. 1 clutch pedal cushion onto the clutch pedal sub-assembly.
31301Q
3.INSTALL CLUTCH PEDAL SPRING BUSH
Apply MP grease to the 2 clutch pedal spring bushes.
Install the 2 clutch pedal spring bushes onto the clutch pedal sub-assembly.
31301
4.INSTALL CLUTCH PEDAL SUB-ASSEMBLY
| *A | for LHD |
| *B | for RHD |
Apply MP grease to the contact surfaces between the clutch pedal sub-assembly and clutch pedal spring, and clutch pedal bracket and clutch pedal spring.
Install the clutch pedal spring onto the clutch pedal sub-assembly.
Connect the clutch pedal spring from the clutch pedal bracket.
Apply MP grease to the clutch pedal shaft flange.
Install the clutch pedal sub-assembly onto the clutch pedal bracket with the clutch pedal shaft and nut.
Hold the clutch pedal shaft and tighten the nut.
Install the clutch pedal shaft from the right side of the vehicle.
31340
5.CONNECT CLUTCH RELEASE CABLE ASSEMBLY
Apply MP grease to the cable end and pedal hook.
Connect the end of the clutch release cable assembly to the clutch pedal sub-assembly.
84520
6.INSTALL CLUTCH START SWITCH ASSEMBLY
Install the clutch start switch assembly so that its end touches the No. 1 clutch pedal cushion.
Tighten the lock nut to the specified torque when adjusting the clutch pedal sub-assembly.
Connect the connector to the clutch start switch assembly.
Attach the 2 harness clamps to the clutch pedal bracket. (for RHD)
31301
7.INSPECT AND ADJUST CLUTCH PEDAL SUB-ASSEMBLY
55458B
8.INSTALL INSTRUMENT PANEL LOWER COVER (for RHD)
Click hereVehicle Interior>INTERIOR PANELS / TRIM>LOWER INSTRUMENT PANEL>INSTALLATION
Use the same procedure as for the LH side.