Home › Power Source / Network › 1NR-VE BATTERY / CHARGING › CHARGING SYSTEM › from 2015.08
RM19Y0E _57 Power Source / Network _041458 1NR-VE BATTERY / CHARGING _0192571 CHARGING SYSTEM C

1NR-VE BATTERY / CHARGING  CHARGING SYSTEM  P1550  Battery Current Sensor Signal Malfunction  


DESCRIPTION

The battery current sensor assembly detects the charge/discharge current of the battery. By converting this signal into voltage, the battery current sensor assembly transmits it to the ECM. Based on this voltage signal, the ECM then sends a power generation command to the alternator assembly.

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Memory
P1550 Battery Current Sensor Signal Malfunction Diagnosis condition: Ignition switch ON
Abnormal condition:
Output voltage of battery current sensor assembly: lower than 0.15 V or 4.85 V or higher
Duration of abnormality: 0.5 seconds or more
Number of trips: 1 trip
·

Battery current sensor assembly

·

Wire harness and connector

·

ECM


Charging warning light comes on DTC stored

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (BATTERY CURRENT SENSOR ASSEMBLY - ECM)
a.

Disconnect the C42 battery current sensor assembly connector.


b.

Disconnect the C50 ECM connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
C42-3 (VOUT) - C50-78 (CM) Always Below 1 Ω
C42-2 (VDD) - C50-56 (VC) Always Below 1 Ω
C42-4 (GND) - C50-100 (E2) Always Below 1 Ω
C42-3 (VOUT) or C50-78 (CM) - Body ground and other terminals Always 10 kΩ or higher
C42-2 (VDD) or C50-56 (VC) - Body ground and other terminals Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

2.REPLACE BATTERY CURRENT SENSOR ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.REPLACE BATTERY CURRENT SENSOR ASSEMBLY
a.

Replace the battery current sensor assembly with a new one.

Click herePower Source / Network>1NR-VE BATTERY / CHARGING>BATTERY CURRENT SENSOR>REMOVAL


Result:
Proceed to
NEXT



NEXT

3.CLEAR DTC
3.CLEAR DTC
a.

Turn the ignition switch to ON.


b.


NEXT

4.CHECK DTC (Present and Past DTCs)
4.CHECK DTC (Present and Past DTCs)
a.

Check for DTCs.

Click herePower Source / Network>1NR-VE BATTERY / CHARGING>CHARGING SYSTEM>DTC CHECK / CLEAR

Result:
Proceed to
DTC is output
DTC is not output




DTC is output

DTC is not output

END