The power steering ECU assembly receives vehicle speed signals from the combination meter assembly via CAN communication. The power steering ECU provides the appropriate assisting force in accordance with the vehicle speed based on these signals.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate | Return-to-normal Condition | Note |
|---|---|---|---|---|---|---|
| C1541/41 | Vehicle Speed Abnormality | An abnormal vehicle speed signal is received | ·
Speed sensor circuit ·
Anti-lock Brake System ·
CAN communication system |
Comes on (Red) | Ignition switch ON again or after system confirmed to be normal | - |
| C1571/71 | Vehicle Speed Test not Completed | A speed sensor malfunction (Test Mode DTC) | ·
Speed sensor circuit ·
Anti-lock Brake System ·
CAN communication system |
Blinks | Vehicle speed at 20 km/h (12 mph) or more for 2 seconds or more | - |
Check if DTC U0155/62 is output.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTC U0155/62 is not output | A |
| DTC U0155/62 is output | B |
A
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Connect the GTS or Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the GTS or Techstream on.
Enter the following menus: Chassis / EPS / Data List.
Select the item "Vehicle Speed" in the Data List and read the value displayed on the GTS or Techstream.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Vehicle speed | Vehicle speed from meter | Min.: 0 km/h (0 mph)
Max.: 255 km/h (158.5 mph) |
Vehicle stopped: 0 km/h (0 mph)
Vehicle driven at constant speed: No significant fluctuation |
- |
| Tester Display |
|---|
| Vehicle speed |
The normal condition value is displayed on the GTS or Techstream.
| Proceed to |
|---|
| OK |
| NG |
OK
NG