Use these procedures to troubleshoot the power steering system.
*: Use the GTS or Techstream.
| Proceed to |
|---|
| NEXT |
NEXT
Confirm the problem symptoms.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>PROBLEM SYMPTOMS TABLE
| Proceed to |
|---|
| NEXT |
NEXT
Measure the voltage of the battery.
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
Using the GTS or Techstream, inspect the battery voltage reduction history by reading "Battery Voltage Lo Record" in the Data List.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DATA LIST / ACTIVE TEST
| Proceed to |
|---|
| NEXT |
NEXT
Record DTCs and freeze frame data.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>FREEZE FRAME DATA
| Proceed to |
|---|
| NEXT |
NEXT
Clear DTCs and freeze frame data.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>FREEZE FRAME DATA
| Proceed to |
|---|
| NEXT |
NEXT
| Result | Proceed to |
|---|---|
| Symptom does not occur | A |
| Symptom occurs | B |
A
B
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR
Refer to the diagnostic trouble code chart when any DTCs are output.
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output | B |
A
B
Refer to the Problem Symptoms Table.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>PROBLEM SYMPTOMS TABLE
| Result | Proceed to |
|---|---|
| Fault is not listed in Problem Symptoms Table | A |
| Fault is listed in Problem Symptoms Table | B |
A
B
Refer to Terminals of ECU.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>TERMINALS OF ECU
Refer to Data List/Active Test.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DATA LIST / ACTIVE TEST
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT