Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM › from 2015.08
RM19Y0E _55 Steering _002997 POWER ASSIST SYSTEMS _0015160 POWER STEERING SYSTEM C

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  C1573/73  Engine Speed Test not Completed  


DESCRIPTION

The power steering ECU receives engine speed signals from the ECM via CAN communication. The power steering ECU provides the appropriate assisting force in accordance with the engine speed based on these signals.

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Return-to-normal Condition Note
C1573/73 Engine Speed Test not Completed An engine speed signal error (Test Mode DTC)
·

Engine speed signal circuit

·

ECM

·

CAN communication system


Blinks Engine Speed at 450 rpm or more for 2 seconds or more -

PROCEDURE

1.CHECK FOR OTHER DTC OUTPUT (CAN COMMUNICATION SYSTEM)
a.

Check if DTC U0100/61 is output.

Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR

Result:
Result Proceed to
DTC U0100/61 is not output A
DTC U0100/61 is output B


HINT:

DTC U0100/61 indicates a ECM communication malfunction in the power steering system.




A

2.CHECK FOR DTC (ENGINE CONTROL SYSTEM)

B

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)

2.CHECK FOR DTC (ENGINE CONTROL SYSTEM)
a.

Using the GTS or Techstream, check for DTCs and confirm that there are no problems in the engine control system.

OK:

DTCs for ECM are not output.


Result:
Result Proceed to
DTC is not output A
DTC is output (for 1NR-VE) B
DTC is output (for 2NR-VE w/ Air Fuel Ratio Sensor) C
DTC is output (for 2NR-VE w/o Air Fuel Ratio Sensor) D




A

B

C

D