Home › Brake › BRAKE (REAR) › REAR BRAKE FLEXIBLE HOSE › from 2015.08
RM19Y0E _54 Brake _002995 BRAKE (REAR) _0015154 REAR BRAKE FLEXIBLE HOSE A

BRAKE (REAR)  REAR BRAKE FLEXIBLE HOSE  INSTALLATION  


PROCEDURE

Hide 47316A 1.INSTALL REAR BRAKE TUBE FLEXIBLE HOSE

a.

Install the rear brake tube flexible hoses with 4 new clips.


b.

Using union nut wrench, install the brake tubes onto the rear brake tube flexible hoses.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



Hide 2. FILL RESERVOIR WITH BRAKE FLUID

Hide 3.BLEED CLUTCH LINE (for 2NR-VE with Manual Transmission)

Hide 4.BLEED MASTER CYLINDER

Hide 6. CHECK FLUID LEVEL IN RESERVOIR

Hide 7.INSPECT FOR BRAKE FLUID LEAK

Hide 8.INSTALL REAR WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)