Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM › from 2013.04
RM19Y0E _58 Vehicle Interior _003010 SUPPLEMENTAL RESTRAINT SYSTEMS _0015213 AIRBAG SYSTEM C

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG SYSTEM  B1652/34  Connecter Half-connecting  


DESCRIPTION

The center airbag sensor assembly vehicle side connector uses connector position assurance terminals that detect the connection state of the connectors.

When the center airbag sensor assembly connector is not connected properly, or there is a malfunction in the connector position assurance terminal, DTC B1652/34 is stored in the center airbag sensor assembly.

DTC No. Detection Item DTC Detection Condition Trouble Area Test Mode / Check Mode
B1652/34 Connecter Half-connecting One of the following conditions is met:
·

A malfunction in the wire harness connector between the center airbag sensor assembly and instrument panel wire.

·

A malfunction in the wire harness connector between the center airbag sensor assembly and floor wire.

·

An center airbag sensor assembly malfunction


·

Instrument panel wire

·

Floor wire

·

Center airbag sensor assembly


DTC is output in check mode

CAUTION / NOTICE / HINT

NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION

·

When disconnecting the cable from the negative (-) battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION



HINT:
·

Perform the simulation method by selecting CHECK MODE (signal check) with the intelligent tester or Techstream.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>CHECK MODE PROCEDURE

·

After selecting CHECK MODE (signal check), perform the simulation method by wiggling each connector of the airbag system or driving the vehicle on a city or rough road.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DIAGNOSIS SYSTEM



PROCEDURE

1.CHECK CONNECTION OF CONNECTORS
a.

Check that the connectors are properly connected to the instrument panel wire, floor wire and center airbag sensor assembly.

OK:

The connectors are properly connected.



Result:
Proceed to
OK
NG



OK

2.CHECK CONNECTORS

NG

CONNECT CONNECTOR PROPERLY

2.CHECK CONNECTORS
a.

Turn the ignition switch off.


b.

Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.


c.

Disconnect the connectors from the center airbag sensor assembly.


d.

Check that the connectors (on the instrument panel wire side, floor wire side and center airbag sensor assembly side) are not damaged.

Result:
Result Proceed to
No problem A
NG (Center airbag sensor assembly) B
NG (Instrument panel wire) C
NG (Floor wire) D




A

3.CHECK DTC

B

C

REPLACE INSTRUMENT PANEL WIRE

D

REPLACE FLOOR WIRE

3.CHECK DTC
a.

Connect the connectors to the center airbag sensor assembly.


b.

Connect the negative (-) terminal cable to the battery, and wait for at least 2 seconds.


c.

Turn the ignition switch to ON, and wait for at least 60 seconds.


d.

Clear the DTCs stored in the memory.


e.

Check for DTCs.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR

OK:

DTC B1652/34 is not output



Result:
Proceed to
OK
NG



OK

NG