77404
1.INSTALL FUEL TANK VENT HOSE SUB-ASSEMBLY
Engage the 2 clamps to install the fuel tank vent hose sub-assembly to the fuel tank assembly.
77209F
2.INSTALL FUEL TANK MAIN TUBE SUB-ASSEMBLY
Engage the 4 clamps to install the fuel tank main tube sub-assembly to the fuel tank assembly.
77100
3.INSTALL FUEL TANK ASSEMBLY
The fuel tank assembly is very heavy. Be sure to follow the procedure described in the repair manual, or the fuel tank assembly may fall off the engine lifter.
Set the fuel tank assembly on an engine lifter.
Using height adjustment attachments and plate lift attachments, keep the fuel tank assembly horizontal.
Using the engine lifter, slowly raise the fuel tank assembly, and then temporarily install the fuel tank assembly with the 4 bolts.
Install the fuel tank side plate to the fuel tank assembly.
Tighten the 4 bolts in the order shown in the illustration.
Be careful not to drop the fuel tank assembly.
When installing the fuel tank assembly, tilt it slightly to prevent it from interfering with the surrounding parts.
77404
4.CONNECT FUEL TANK VENT HOSE SUB-ASSEMBLY
Connect the fuel tank vent hose sub-assembly to the canister (charcoal canister assembly).
Click hereEngine / Hybrid System>2ZR-FXE (FUEL)>FUEL SYSTEM>PRECAUTION
77209F
5.CONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY
Connect the fuel tank main tube sub-assembly to the fuel pipe.
Click hereEngine / Hybrid System>2ZR-FXE (FUEL)>FUEL SYSTEM>PRECAUTION
77213E
6.CONNECT FUEL TANK TO FILLER PIPE HOSE
| *a | 120° |
| *b | 15° |
| *c | Top of Vehicle |
| *d | Paint Mark (Fuel Tank To Filler Pipe Hose) |
| *e | Protrusion (Fuel Tank Assembly) |
Connect the fuel tank to filler pipe hose to the fuel tank assembly and tighten the clamp to secure it.
Make sure the clamp and fuel tank to filler pipe hose are positioned within the area shown in the illustration.
77226A
7.CONNECT FUEL TANK BREATHER TUBE
Connect the fuel tank breather tube to the fuel tank filler pipe sub-assembly.
Click hereEngine / Hybrid System>2ZR-FXE (FUEL)>FUEL SYSTEM>PRECAUTION
77641A
8.INSTALL NO. 1 FUEL TANK PROTECTOR
Install the No. 1 fuel tank protector to the fuel tank assembly with the 4 clips.
57628C
9.INSTALL REAR FLOOR SIDE MEMBER COVER LH
Install the rear floor side member cover LH with the clip (B).
Install the 3 bolts and clip (A).
57627A
10.INSTALL REAR FLOOR SIDE MEMBER COVER RH
Install the rear floor side member cover RH with the clip.
Install the 3 bolts.
17430
11.INSTALL TAIL EXHAUST PIPE ASSEMBLY
77020A
12.INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
13.ADD FUEL
14.INSPECT FOR EXHAUST GAS LEAK
If gas is leaking, tighten the areas necessary to stop the leak. Replace damaged parts as necessary.
Perform "Inspection After Repairs" after repairing or replacing the exhaust system.
Click hereEngine / Hybrid System>2ZR-FXE (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION