Home › Engine / Hybrid System › 2ZR-FXE (EMISSION CONTROL) › CANISTER › 2016.10–2018.05
RM32K0E _51 Engine / Hybrid System _060064 2ZR-FXE EMISSION CONTROL _0294229 CANISTER A

2ZR-FXE EMISSION CONTROL  CANISTER  INSTALLATION  


PROCEDURE

Hide 77740 1.INSTALL CANISTER (CHARCOAL CANISTER ASSEMBLY)

a.
A393941

Install the canister (charcoal canister assembly) to the vehicle body as shown in the illustration.


b.

Install the bolt.

Torque:
10.5 N*m (107 kgf*cm, 8 ft.*lbf)


c.

Connect the charcoal canister hose to the canister (charcoal canister assembly) and slide the clip to secure it.


d.
A393942C01
1.583,2.75 1.917,2.75 false 1.99,2.646 2.302,2.802 0.313,0.156 10 false *a
*a Retainer
V100135

Push in


Push the fuel tank vent hose onto the canister (charcoal canister assembly) and push in the retainer to engage the lock claws.

NOTICE:
·

Check that there are no scratches or foreign matter around the connecting parts of the tube connector and pipe (canister (charcoal canister assembly)) before performing this work.

·

After connecting the fuel tank vent hose, check that the fuel tank vent hose is securely connected by pulling on the tube connector.




e.

Push in the fuel tank vent hose sub-assembly to the pipe (canister (charcoal canister assembly)) until the fuel tank vent hose sub-assembly makes a "click" sound.

NOTICE:
·

Check that there are no scratches or foreign matter around the connecting parts of the tube connector and pipe (canister (charcoal canister assembly)) before performing this work.

·

After connecting the fuel tank vent hose sub-assembly, check that the fuel tank vent hose sub-assembly is securely connected by pulling on the tube connector.




Hide 48832A 2.INSTALL REAR NO. 1 STABILIZER BAR BRACKET

a.

Install the 2 rear No. 1 stabilizer bar brackets to the vehicle body with the 4 bolts.

Torque:
78 N*m (795 kgf*cm, 58 ft.*lbf)


Hide 57628C 3.INSTALL REAR FLOOR SIDE MEMBER COVER LH

Hide 57627A 4.INSTALL REAR FLOOR SIDE MEMBER COVER RH

Hide 17430 5.INSTALL TAIL EXHAUST PIPE ASSEMBLY

Hide 6.INSPECT FOR EXHAUST GAS LEAK

If gas is leaking, tighten the areas necessary to stop the leak. Replace damaged parts as necessary.

HINT:

Perform Inspection After Repair after repairing an exhaust gas leak.

Click hereEngine / Hybrid System>2ZR-FXE (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION