Home › Brake › PARKING BRAKE › ELECTRIC PARKING BRAKE ECU › 2016.10–2018.05
RM32K0E _54 Brake _060048 PARKING BRAKE _0297946 ELECTRIC PARKING BRAKE ECU A

PARKING BRAKE  ELECTRIC PARKING BRAKE ECU  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

The parking brake indicator light blinks (red) when the power switch is turned on (IG) after replacing the parking brake ECU assembly. Operate the electric parking brake switch to turn off the parking brake indicator light.


PROCEDURE

Hide 89050 1.INSTALL PARKING BRAKE ECU ASSEMBLY

a.

Install the parking brake ECU assembly with the 2 nuts.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


b.

Connect the 2 parking brake ECU assembly connectors.


Hide 64740C 2.INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH

HINT:

Use the same procedure as for the RH side.

Click hereVehicle Interior>SEAT BELT>REAR SEAT OUTER BELT ASSEMBLY>INSTALLATION


Hide 3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Click herePower Source / Network>2ZR-FXE (BATTERY / CHARGING)>AUXILIARY BATTERY>INSTALLATION

NOTICE:

When disconnecting the cable from the negative (-) battery terminal, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION