Home › Engine / Hybrid System › 2ZR-FXE (LUBRICATION) › OIL PUMP › 2016.10–2019.09
RM32K0E _51 Engine / Hybrid System _060779 2ZR-FXE LUBRICATION _0298021 OIL PUMP A

2ZR-FXE LUBRICATION  OIL PUMP  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during oil pump assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: When performing learning using the GTS.

Click here(Click here)

Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Simple intelligent parking assist system*1
Toyota parking assist-sensor system*1
Pre-collision system
Initialize back door lock Power door lock control system (Click here)
Suspension, tires, etc.
(The vehicle height changes because of suspension or tire replacement)
Initialize No. 1 headlight ECU sub-assembly LH Automatic headlight beam level control system (Click here)
Front wheel alignment adjustment
1.

Clear zero point calibration data.

2.

Perform yaw rate and acceleration sensor zero point calibration.


·

DTCs are stored

·

ABS warning light illuminates

·

Brake warning light/yellow (minor malfunction) illuminates

·

Slip indicator light illuminates

·

VSC disabled or malfunctions


for Initialization:
(Click here)
for Calibration:
(Click here)

PROCEDURE

Hide 13521 2.REMOVE CRANKSHAFT TIMING SPROCKET

Hide 13507 3.REMOVE NO. 2 CHAIN SUB-ASSEMBLY

Hide 12102A 4.REMOVE NO. 2 OIL PAN SUB-ASSEMBLY

Hide 15100 5.REMOVE OIL PUMP ASSEMBLY

a.
A377088

Remove the 3 bolts and oil pump assembly from the stiffening crankcase assembly.