Home › Engine / Hybrid System › CRUISE CONTROL › MILLIMETER WAVE RADAR SENSOR › 2016.10–2020.08
RM32K0E _51 Engine / Hybrid System _061336 CRUISE CONTROL _0299673 MILLIMETER WAVE RADAR SENSOR A

CRUISE CONTROL  MILLIMETER WAVE RADAR SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

If the millimeter wave radar sensor assembly has been struck or dropped, replace the millimeter wave radar sensor assembly with a new one.


PROCEDURE

Hide 1.INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY

NOTICE:

If the front bumper assembly or radiator grill has been replaced, check that the beam axis change mechanism is at the standard position (centered).


a.
C365305C02
2.625,1.125 2.792,1.292 0.167,0.167 10 true 1 0.719,0.99 0.896,1.167 0.177,0.177 10 true 2 2.125,0.396 2.292,0.573 0.167,0.177 10 true 3
V100135

Bolt
V100136

Screw


Engage the 2 guides.


b.

Install the millimeter wave radar sensor assembly with the 2 bolts and screw.

Torque:
Bolt : 5.0 N*m (51 kgf*cm, 44 in.*lbf)

HINT:

Tighten the bolts in the order shown in the illustration.



Hide 88215 2.INSTALL NO. 1 MILLIMETER WAVE RADAR SENSOR BRACKET

a.

Engage the guide.


b.

Install the No. 1 millimeter wave radar sensor bracket with the 2 bolts.

Torque:
Bolt : 5.0 N*m (51 kgf*cm, 44 in.*lbf)


Hide 3.INSTALL FRONT BUMPER ASSEMBLY

Hide 4.ADJUST MILLIMETER WAVE RADAR SENSOR

a.

When the millimeter wave radar sensor assembly or No. 1 millimeter wave radar sensor bracket is replaced with a new one, adjustment of the radar sensor beam axis must be performed.

Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT