Home › Suspension › REAR SUSPENSION › REAR STABILIZER BAR › 2016.10–2019.09
RM32K0E _53 Suspension _061339 REAR SUSPENSION _0299703 REAR STABILIZER BAR A

REAR SUSPENSION  REAR STABILIZER BAR  INSTALLATION  


PROCEDURE

Hide 48818 1.INSTALL REAR STABILIZER BUSHING

a.

Install the 2 rear stabilizer bushings to the rear stabilizer bar.

NOTICE:

Be sure to install the rear stabilizer bushings so that each cutout faces the front of the vehicle.



Hide 48832A 2.INSTALL REAR NO. 1 STABILIZER BAR BRACKET

a.
C365347C01
0.781,1.813 0.927,1.813 0.927,1.813 1.188,1.521 true 0.594,1.698 0.938,1.896 0.344,0.198 10 false *a
*a Arrow Mark
V100135

Front of the Vehicle


Install the 2 rear No. 1 stabilizer bar brackets to the 2 rear stabilizer bushings.

NOTICE:

Be sure to install the rear No. 1 stabilizer bar brackets so that each arrow mark faces the front of the vehicle.



Hide 48812 3.INSTALL REAR STABILIZER BAR

a.
C365348C01
0.281,1.167 0.469,0.958 true 0.5,0.531 0.656,0.729 0.156,0.198 10 true A 0.49,1.24 0.646,1.438 0.156,0.198 10 true B 2.802,0.5 2.958,0.698 0.156,0.198 10 true A 2.865,1.271 3.021,1.469 0.156,0.198 10 true B 0.146,1.177 0.302,1.375 0.156,0.198 10 true *a
*a Identification Mark


Install the rear stabilizer bar, 2 rear No. 1 stabilizer bar brackets and 2 rear stabilizer bushings to the rear suspension member sub-assembly with the 4 bolts.

Torque:
78 N*m (795 kgf*cm, 58 ft.*lbf)

NOTICE:
·

Ensure that the identification mark faces the right side of the vehicle.

·

Temporarily tighten bolt (A) and then fully tighten the 2 bolts in the order of (B) and (A).




Hide 48840A 5.INSTALL REAR STABILIZER LINK ASSEMBLY LH

a.
C365342N01
1.583,1.427 1.74,1.625 0.156,0.198 10 true A 1.146,4.24 1.302,4.438 0.156,0.198 10 true B

Install the rear stabilizer link assembly LH with the nut (A).

Torque:
75 N*m (765 kgf*cm, 55 ft.*lbf)

HINT:

If the ball joint turns together with the nut, use a 6 mm hexagon socket wrench to hold the stud bolt.



b.

Install the rear stabilizer link assembly LH with the bolt and nut (B).

Torque:
75 N*m (765 kgf*cm, 55 ft.*lbf)

NOTICE:

When installing the nut, keep the bolt from rotating.



Hide 48830D 6.INSTALL REAR STABILIZER LINK ASSEMBLY RH

HINT:

Perform the same procedure as for the LH side.


Hide 57628C 7.INSTALL REAR FLOOR SIDE MEMBER COVER LH

Hide 57627A 8.INSTALL REAR FLOOR SIDE MEMBER COVER RH

Hide 9.INSTALL REAR WHEEL