Home › Power Source / Network › 2ZR-FXE (BATTERY / CHARGING) › BATTERY CURRENT SENSOR › 2016.10–2019.09
RM32K0E _57 Power Source / Network _060220 2ZR-FXE BATTERY / CHARGING _0300002 BATTERY CURRENT SENSOR A

2ZR-FXE BATTERY / CHARGING  BATTERY CURRENT SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the battery state sensor assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link

*1: When performing learning using the GTS.

Click here(Click here)

Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Simple intelligent parking assist system*1
Toyota parking assist-sensor system*1
Pre-collision system
Initialize back door lock Power door lock control system (Click here)

PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 28850C 2.REMOVE BATTERY STATE SENSOR ASSEMBLY

a.
A392499

Disengage the 2 claws and disconnect the wire harness from the battery current sensor holder.


b.

Disconnect the battery state sensor assembly connector.


c.
A392500

Remove the nut and disconnect the engine wire from the battery state sensor assembly.

NOTICE:

When disconnecting the engine wire, some systems need to be initialized after the engine wire is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION



d.
A392501

Loosen the nut and remove the battery state sensor assembly from the auxiliary battery.


e.
A392502

Disengage the 2 claws to remove the battery state sensor assembly from the battery current sensor holder.