Use the same procedure for LHD and RHD vehicles.
The procedure listed below is for the LHD vehicles.
63311C
1.INSTALL ROOF HEADLINING
|
Install in this Direction |
Insert the roof headlining assembly into the cabin from the back door.
Check that the corners of the roof headlining are not folded, twisted or otherwise deformed and that none of the mounted parts have fallen off.
Make sure that the roof headlining does not get caught on anything as it may become bent or damaged.
Do not damage the roof headlining or vehicle interior.
Engage the guides and set the roof headlining assembly.
Install the 3 clips.
for Roof Panel Side:
w/ Lane Departure Alert System:
Connect the ground wire with the nut.
w/ Digital Audio Broadcasting Antenna:
Connect the connector.
Engage the clamp to connect the wire harness.
| *A | w/ Lane Departure Alert System |
| *B | w/ EC Mirror |
| *C | w/ Rain Sensor |
for Windshield Glass Side:
Connect each connector.
for Rear Pillar RH Side:
Connect the connector.
for Front Pillar RH Side:
Engage the wire harness clamps.
Connect the connector.
for Front Pillar LH Side:
Engage the wire harness clamps.
Connect the 2 connectors.
74612
2.INSTALL ASSIST GRIP COVER
Use the same procedures for the opposite side.
Install the 2 assist grip covers and 2 clips to the assist grip sub-assembly.
74610A
3.INSTALL ASSIST GRIP SUB-ASSEMBLY
Use the same procedures for the opposite side.
|
Install in this Direction |
Engage the clips to install the assist grip sub-assembly as shown in the illustration.
74348
4.INSTALL VISOR HOLDER
Use the same procedures for the opposite side.
|
Install in this Direction |
Engage the claws to install the base as shown in the illustration.
|
Install in this Direction |
Install the holder as shown in the illustration.
74320
5.INSTALL VISOR ASSEMBLY LH (w/o Vanity Light)
Engage the guide to install the visor assembly LH.
Using a T10H "TORX" driver, install the 2 screws.
74310
6.INSTALL VISOR ASSEMBLY RH (w/o Vanity Light)
Use the same procedure as for the LH side.
74320
7.INSTALL VISOR ASSEMBLY LH (w/ Vanity Light)
74310
8.INSTALL VISOR ASSEMBLY RH (w/ Vanity Light)
Use the same procedure as for the LH side.
74325
9.INSTALL VISOR BRACKET COVER
Use the same procedures for the opposite side.
|
Install in this Direction |
Engage the claws to install the visor bracket cover as shown in the illustration.
89732A
10.INSTALL THEFT WARNING ULTRASONIC SENSOR (w/ Intrusion Sensor)
81240
11.INSTALL NO. 1 ROOM LIGHT ASSEMBLY (w/ Map Light)
81260A
12.INSTALL MAP LIGHT ASSEMBLY (w/ Map Light)
81340
13.INSTALL VANITY LIGHT ASSEMBLY (w/ Vanity Light)
87834
14.INSTALL INNER REAR VIEW MIRROR STAY HOLDER COVER (w/ EC Mirror)
86466D
15.INSTALL NO. 1 FORWARD RECOGNITION COVER (w/ Lane Departure Alert System)
86466E
16.INSTALL NO. 2 FORWARD RECOGNITION COVER (w/ Lane Departure Alert System)
89943
17.INSTALL RAIN SENSOR COVER (w/ Rain Sensor)
62480A
18.INSTALL ROOF SIDE INNER GARNISH ASSEMBLY LH
When reusing the roof side inner garnish assembly LH:
Install 5 new clips to the roof side inner garnish assembly LH.
|
Install in this Direction (1) |
|
Install in this Direction (2) |
Engage the guide and clips to install the roof side inner garnish assembly LH as shown in the illustration.
62470A
19.INSTALL ROOF SIDE INNER GARNISH ASSEMBLY RH
Use the same procedure as for the LH side.
64740C
20.INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH
Connect the rear seat 3 point type outer belt assembly LH.
|
Install in this Direction |
Engage the clips and claws to install the deck trim side panel assembly LH as shown in the illustration.
w/ Hook:
Install the luggage hold belt striker with the bolt.
w/o Hook:
Install the clip.
64730B
21.INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH
Use the same procedure as for the LH side.
64715C
22.INSTALL DECK TRIM SIDE COVER LH (w/ Cover)
|
Install in this Direction (1) |
|
Install in this Direction (2) |
Engage the guides to install the deck trim side cover LH as shown in the illustration.
Turn the cover knob as shown in the illustration and lock it.
64714C
23.INSTALL DECK TRIM SIDE COVER RH (w/ Cover)
Use the same procedure as for the LH side.
81330
24.INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY (w/ Luggage Compartment Room Light)
64716D
25.INSTALL DECK TRIM REAR COVER
|
Install in this Direction |
Engage the guides, claws and clips to install the deck trim rear cover as shown in the illustration.
w/ Hook:
Install the 2 luggage hold belt strikers with 2 bolts.
w/o Hook:
Install the 2 clips.
62420A
26.INSTALL CENTER PILLAR GARNISH ASSEMBLY LH
When reusing the center pillar garnish assembly LH:
Install a new clip to the center pillar garnish assembly LH.
|
Install in this Direction (1) |
|
Install in this Direction (2) |
Engage the guides and clip to install the center pillar garnish assembly LH as shown in the illustration.
Install the 2 clips.
62410A
27.INSTALL CENTER PILLAR GARNISH ASSEMBLY RH
Use the same procedure as for the LH side.
62414A
28.INSTALL CENTER PILLAR LOWER GARNISH LH
|
Install in this Direction |
Engage the clips and claws to install the center pillar lower garnish LH as shown in the illustration.
62413A
29.INSTALL CENTER PILLAR LOWER GARNISH RH
Use the same procedure as for the LH side.
73220
30.CONNECT FRONT SEAT OUTER BELT ASSEMBLY LH
73210
31.CONNECT FRONT SEAT OUTER BELT ASSEMBLY RH
Use the same procedure as for the LH side.
73233
32.INSTALL LAP BELT OUTER ANCHOR COVER
62552F
33.INSTALL REAR SEAT SIDE GARNISH LH
|
Install in this Direction |
Engage the guide, claws and clip to install the rear seat side garnish LH as shown in the illustration.
62551F
34.INSTALL REAR SEAT SIDE GARNISH RH
Use the same procedure as for the LH side.
71304C
35.INSTALL REAR SEATBACK HINGE SUB-ASSEMBLY LH
Install the rear seatback hinge sub-assembly LH with the bolt.
71303C
36.INSTALL REAR SEATBACK HINGE SUB-ASSEMBLY RH
Use the same procedure as for the LH side.
62332A
37.INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH
62331A
38.INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH
Use the same procedure as for the LH side.
76974F
39.INSTALL REAR UNDER SIDE COVER LH
|
Install in this Direction |
Engage the guide, claw and clips to install the rear under side cover LH as shown in the illustration.
Install the 2 clips.
76973F
40.INSTALL REAR UNDER SIDE COVER RH
Use the same procedure as for the LH side.
67918A
41.INSTALL REAR DOOR SCUFF PLATE LH
|
Install in this Direction |
Engage the claws to install the rear door scuff plate LH as shown in the illustration.
67917A
42.INSTALL REAR DOOR SCUFF PLATE RH
Use the same procedure as for the LH side.
62212
43.INSTALL FRONT PILLAR GARNISH LH
62211
44.INSTALL FRONT PILLAR GARNISH RH
Use the same procedure as for the LH side.
62312B
45.INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH
62311B
46.INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH
Use the same procedure as for the LH side.
62112
47.INSTALL COWL SIDE TRIM BOARD LH
62111C
48.INSTALL COWL SIDE TRIM BOARD RH
Use the same procedure as for the LH side.
67914
49.INSTALL FRONT DOOR SCUFF PLATE LH
67913
50.INSTALL FRONT DOOR SCUFF PLATE RH
Use the same procedure as for the LH side.
64997
51.INSTALL DECK FLOOR BOX LH (w/ Deck Floor Box)
|
Install in this Direction |
for Type A:
Engage the guide to install the deck floor box LH as shown in the illustration.
|
Install in this Direction |
for Type B:
Engage the guide to install the deck floor box LH as shown in the illustration.
64995
52.INSTALL DECK FLOOR BOX RH (w/ Deck Floor Box)
|
Install in this Direction |
for Type A:
Engage the guide to install the deck floor box RH as shown in the illustration.
|
Install in this Direction |
for Type B:
Engage the guide to install the deck floor box RH as shown in the illustration.
64777J
53.INSTALL SPARE WHEEL CUSHION (w/ Deck Board)
|
Install in this Direction |
for Type A:
Install the spare wheel cushion as shown in the illustration.
|
Install in this Direction |
for Type B:
Install the spare wheel cushion as shown in the illustration.
|
Install in this Direction |
for Type C:
Install the spare wheel cushion as shown in the illustration.
|
Install in this Direction |
for Type D:
Install the spare wheel cushion as shown in the illustration.
Install the clip.
58410B
54.INSTALL DECK BOARD ASSEMBLY (w/ Deck Board)
|
Hook and Loop Fastener |
|
Install in this Direction |
for Type A:
Install the deck board assembly as shown in the illustration.
Engage the hook and loop fastener.
|
Install in this Direction |
for Type B:
Install the deck board assembly as shown in the illustration.
|
Install in this Direction |
for Type C:
Install the deck board assembly as shown in the illustration.
64910J
55.INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
|
Install in this Direction |
Engage the guides to install the tonneau cover assembly as shown in the illustration.
Engage the hooks.
64330D
56.INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Package Tray Trim)
|
Install in this Direction |
Engage the guides to install the package tray trim panel assembly as shown in the illustration.
Engage the hooks.
57.INSTALL REAR SEAT ASSEMBLY
58.INSTALL FRONT SEAT ASSEMBLY LH
59.INSTALL FRONT SEAT ASSEMBLY RH
Use the same procedure as for the LH side.