Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
73200A
1.INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY
Engage the guide and temporarily install the front shoulder belt anchor adjuster assembly with the 2 bolts.
Tighten the 2 bolts in the order shown in the illustration.
73220
2.INSPECT FRONT SEAT OUTER BELT ASSEMBLY
73220
3.INSTALL FRONT SEAT OUTER BELT ASSEMBLY
Engage the guides to install the front seat outer belt assembly.
Install the bolt.
| *a | Locking Button |
Connect the pretensioner connector and lock the locking button as shown in the illustration.
Securely lock the locking button.
Connect the shoulder anchor of the front seat outer belt assembly with the nut.
Install the bolt of retractor lower side.
Check that the ELR locks.
This check should be performed with the front seat outer belt assembly installed to the vehicle.
With the front seat outer belt assembly installed to the vehicle, check that the belt locks when it is pulled out quickly.
Remove the bolt of retractor lower side.
62420A
4.INSTALL CENTER PILLAR GARNISH ASSEMBLY
62414A
5.INSTALL CENTER PILLAR LOWER GARNISH
73220
6.CONNECT FRONT SEAT OUTER BELT ASSEMBLY
Connect the floor anchor of the front seat outer belt assembly with the bolt.
73233
7.INSTALL LAP BELT OUTER ANCHOR COVER
|
Install in this Direction |
Engage the guide and claws to install the lap belt outer anchor cover.
62332A
8.CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP
Connect the rear door opening trim weatherstrip.
67918A
9.INSTALL REAR DOOR SCUFF PLATE
62312B
10.CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP
Connect the front door opening trim weatherstrip.
67914
11.INSTALL FRONT DOOR SCUFF PLATE
12.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
Click hereGeneral>MAINTENANCE>2ZR-FXE AUXILIARY BATTERY>INSTALLATION
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
13. PERFORM DIAGNOSTIC SYSTEM CHECK
14.INSPECT SRS WARNING LIGHT