Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW REGULATOR MOTOR (for Front Door) › 2016.10–2019.09
RM32K0E _59 Vehicle Exterior _061311 WINDOW / GLASS _0302412 POWER WINDOW REGULATOR MOTOR(for Front Door) A

WINDOW / GLASS  POWER WINDOW REGULATOR MOTOR(for Front Door)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.

·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY

a.

Apply MP grease to the sliding and rotating areas of the power window regulator motor assembly.


b.

Using a T25 "TORX" socket wrench, install the power window regulator motor assembly with the 3 screws.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

HINT:

When replacing a power window regulator motor assembly, a new power window regulator motor assembly uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.



Hide 2.INSTALL FRONT DOOR WINDOW REGULATOR ASSEMBLY

Hide 67831C 3.INSTALL NO. 2 FRONT DOOR SERVICE HOLE COVER

Hide 68102 4.INSTALL FRONT DOOR GLASS SUB-ASSEMBLY

Hide 67832 5.INSTALL FRONT DOOR SERVICE HOLE COVER

Hide 68195 6.INSTALL FRONT DOOR BELT SEAL

Hide 68172A 7.INSTALL FRONT DOOR GLASS INNER WEATHERSTRIP

Hide 67602 8.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

Hide 74231 9.INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for Front Passenger Side)

Hide 74232 10.INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for Driver Side)

Hide 69284C 11.INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG

Hide 12.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 13.INITIALIZE POWER WINDOW CONTROL SYSTEM