If the clearance warning ECU assembly detects an internal malfunction during self-diagnosis, DTC C1611 is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1611 | ECU Malfunction | ·
Sub-CPU abnormal signal ·
Mirror check abnormal |
Clearance warning ECU assembly |
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization may be needed. Refer to Calibration.
Using the GTS, check for DTCs according to the prompts on the screen.
After turning the power switch from off to on (IG), wait 3 seconds or more before checking for DTCs.
Clear the DTCs according to the screen on the GTS.
Recheck for DTCs.
No DTCs are output
| Result |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG