When the clearance warning ECU assembly detects that the steering angle neutral point memorization is incomplete during self diagnosis, C1AEA is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1AEA | Steering Angle Midpoint Initial Setting Incomplete | Steering angle neutral point memorization incomplete | ·
Steering sensor steering angle neutral point memorization incomplete ·
Clearance warning ECU assembly |
If DTCs are output after repairs, turn the power switch on (IG) and the simple intelligent parking assist system on. Then clear the DTCs.
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization may be needed. Refer to Calibration.
Perform steering angle neutral point memorization.
| Proceed to |
|---|
| NEXT |
NEXT
Using the GTS, check for DTCs according to the prompts on the screen.
Clear the DTCs according to the screen on the GTS.
Recheck for DTCs.
If DTC C1AEA is output, perform steering angle neutral point memorization.
If DTC C1AEA is still output after performing steering angle neutral point memorization 3 times, replace the clearance warning ECU assembly.
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG