When the main body ECU (multiplex network body ECU) receives the light control switch position signal, it sends an illumination request signal to the headlight ECU sub-assembly LH and illuminates the clearance lights.
When the operation conditions of the daytime running lights are met, the main body ECU (multiplex network body ECU) sends an illumination request signal to the headlight ECU sub-assembly LH and illuminates the daytime running lights.
If the headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the headlight ECU sub-assembly LH.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>INITIALIZATION
Connect the GTS to the DLC3.
Turn the power switch to on (IG).
Enter the following menus: Body Electrical / HL AutoLeveling / Active Test.
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Clearance Light | Clearance lights | ON or OFF | - |
| Daytime Running Light | Daytime running lights | ON or OFF | - |
| Tester Display |
|---|
| Clearance Light |
| Tester Display |
|---|
| Daytime Running Light |
Clearance lights and daytime running lights illuminate.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for LH Side) | B |
| NG (for RH Side) | C |
A
B
C
Replace the headlight unit assembly LH with a new or known good one.
Click hereVehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY (for LED Headlight)>REMOVAL
Check that the clearance light LH and daytime running light LH operate normally.
Clearance light LH and daytime running light LH operate normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the headlight unit assembly RH with a new or known good one.
Click hereVehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY (for LED Headlight)>REMOVAL
Check that the clearance light RH and daytime running light RH operate normally.
Clearance light RH and daytime running light RH operate normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG