Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › ANTENNA CORD › 2016.10–2019.09
RM32K0E _56 Audio / Visual / Telematics _061290 NAVIGATION / MULTI INFO DISPLAY _0303551 ANTENNA CORD A

NAVIGATION / MULTI INFO DISPLAY  ANTENNA CORD  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced the during antenna cord sub-assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Simple intelligent parking assist system*1
Toyota parking assist-sensor system*1
Pre-collision system
Initialize back door lock Power door lock control system (Click here)

*1: When performing learning using the GTS.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>SIMPLE INTELLIGENT PARKING ASSIST SYSTEM>CALIBRATION

CAUTION:
B458500

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click here


PROCEDURE

Hide 55401E 1.REMOVE INSTRUMENT PANEL SAFETY PAD

Hide 55086 2.REMOVE NO. 3 HEATER TO REGISTER DUCT SUB-ASSEMBLY (for LHD)

Hide 55084E 3.REMOVE NO. 1 HEATER TO REGISTER DUCT SUB-ASSEMBLY (for RHD)

Hide 86101 4.REMOVE ANTENNA CORD SUB-ASSEMBLY (for LHD)

a.

Disengage the clamps to remove the antenna cord sub-assembly.

E353801


b.

Disconnect the connector.


Hide 86101 5.REMOVE ANTENNA CORD SUB-ASSEMBLY (for RHD)

a.

Disengage the clamps to remove the antenna cord sub-assembly.

E353804


b.

Disconnect the connector.


Hide 63311C 6.REMOVE ROOF HEADLINING

Hide 86101J 7.REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY

a.

Type A:

i.

Remove each adhesive tape from the roof headlining.

E359078C01
2.396,2.292 3.031,3.375 0.635,1.083 0.896,2.76 1.021,2.5 true 1.781,2.438 1.469,2.563 true 3.042,2.906 3.302,2.906 true 1.813,2.292 2.125,2.49 0.313,0.198 10 false *b 0.729,2.75 1.042,2.948 0.313,0.198 10 false *a 3.396,2.75 3.677,2.99 0.281,0.24 12 true *A
*A w/ Digital Audio Broadcasting Antenna - -
*a Notch *b Clamp
V100155

Adhesive Tape
V100136

Front



ii.

Disengage the clamp and notch to remove the No. 2 antenna cord sub-assembly from the roof headlining.



b.

Type B:

i.

Remove each adhesive tape from the roof headlining.

E353819C03
2.406,2.323 3.063,3.417 0.656,1.094 0.875,2.125 1.031,2.365 true 1.083,2.813 1.281,2.594 true 3.063,2.885 3.344,2.885 true 0.708,1.979 0.906,2.177 0.198,0.198 10 true *a 0.896,2.708 1.094,2.906 0.198,0.198 10 true *b 3.406,2.771 3.729,3.021 0.323,0.25 12 true *A
*A w/ Digital Audio Broadcasting Antenna - -
*a Notch *b Clamp
V100155

Adhesive Tape
V100136

Front



ii.

Disengage the clamp and notch to remove the No. 2 antenna cord sub-assembly from the roof headlining.



Hide 86101R 8.REMOVE NO. 5 ANTENNA CORD SUB-ASSEMBLY (w/ Digital Audio Broadcasting Antenna)

a.
E353808

Disconnect the connector.


b.

Disengage the clamp to remove the No. 5 antenna cord sub-assembly.


Hide 86101D 9.REMOVE NO. 3 ANTENNA CORD SUB-ASSEMBLY

a.

w/o FM Sub-antenna:

i.
E353809

Disconnect the connector.


ii.

Disengage the clamps.


iii.
E353810C01
0.688,1.323 1.063,1.406 true 2.292,0.771 2.552,0.594 true 0.417,1.208 0.656,1.417 0.24,0.208 10 true *b 2.594,0.417 2.833,0.625 0.24,0.208 10 true *a
*a Guide
*b Clamp


Remove the bolt.


iv.

Disengage the clamp and guide to remove the No. 3 antenna cord sub-assembly.



b.

w/ FM Sub-antenna:

i.
E353812

Disconnect the connector of the No. 4 antenna cord sub-assembly.


ii.
E353809

Disconnect the connector.


iii.

Disengage the clamps.


iv.
E353811C01
2.115,0.833 2.448,0.833 true 1.104,1.5 0.771,1.5 true 2.521,0.719 2.76,0.917 0.24,0.198 10 true *a 0.438,1.396 0.677,1.594 0.24,0.198 10 true *b
*a Guide
*b Clamp


Disconnect the connector of the floor wire.


v.

Remove the bolt.


vi.

Disengage the clamp and guide to remove the No. 3 antenna cord sub-assembly.



Hide 64790B 10.REMOVE BACK DOOR TRIM UPPER PANEL ASSEMBLY (w/ FM Sub-antenna)

Hide 86101Q 11.REMOVE NO. 4 ANTENNA CORD SUB-ASSEMBLY (w/ FM Sub-antenna)

a.
E353813

Disconnect the connector.


b.

Disengage the clamp and 2 grommets to remove the No. 4 antenna cord sub-assembly.