The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the lower No. 1 instrument panel airbag assembly removal/installation are shown below.
*1: When performing learning using the GTS.
Use the same procedure for RHD and LHD vehicles.
The following procedure is for LHD vehicles.
1. PRECAUTION
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
Click hereGeneral>MAINTENANCE>2ZR-FXE AUXILIARY BATTERY>REMOVAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
55545
3.REMOVE FUSE BOX OPENING COVER
55470
4.REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY
55434B
5.REMOVE INSTRUMENT PANEL LOWER CENTER FINISH PANEL
73900
6.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY WITH DOOR
|
Deployment Side |
When storing the lower No. 1 instrument panel airbag assembly with door, keep the airbag deployment side facing upward.
Check that the power switch off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
Remove the 2 bolts.
Disengage the hooks to separate the lower No. 1 instrument panel airbag assembly with door.
When separating the lower No. 1 instrument panel airbag assembly with door, do not pull the airbag wire harness.
| *a | Protective Tape |
| *b | Airbag Connector |
| *c | Airbag Connector Lock |
Using a screwdriver with its tip wrapped in protective tape, release the airbag connector lock.
Disconnect the airbag connector to remove the lower No. 1 instrument panel airbag assembly with door.
When disconnecting any airbag connector, take care not to damage the airbag wire harness.
73997
7.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG DOOR
Disengage the hooks.
Disengage the hooks to remove the lower No. 1 instrument panel airbag door from the lower No. 1 instrument panel airbag assembly.