Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › REAR CROSSING TRAFFIC ALERT BUZZER › 2016.10–2019.09
RM32K0E _56 Audio / Visual / Telematics _060599 PARK ASSIST / MONITORING _0304152 REAR CROSSING TRAFFIC ALERT BUZZER A

PARK ASSIST / MONITORING  REAR CROSSING TRAFFIC ALERT BUZZER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the blind spot monitor buzzer removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effect/Inoperative when not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Simple intelligent parking assist system*1
Toyota parking assist-sensor system*1
Pre-collision system
Initialize back door lock Power door lock control system (Click here)

*1: When performing learning using the GTS.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>SIMPLE INTELLIGENT PARKING ASSIST SYSTEM>CALIBRATION

CAUTION:
B458500

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


NOTICE:

If the front seat airbag assembly has been deployed, replace the front seat airbag assembly, front seatback frame sub-assembly, separate type front seatback pad and separate type front seatback cover with the necessary parts in accordance with the extent of the collision damage.


HINT:
·

Use the same procedure for LHD and RHD vehicles.

·

The procedure listed below is for the LHD vehicles.



PROCEDURE

Hide 73900 1.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (for LHD with Driver Side Knee Airbag)

Hide 55545 2.REMOVE FUSE BOX OPENING COVER (for LHD without Driver Side Knee Airbag)

Hide 55550 3.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY (for RHD)

Hide 89747F 4.REMOVE BLIND SPOT MONITOR BUZZER

a.
E357017

for LHD:

i.

Using a clip remover, disengage the clamp.


ii.

Disconnect the connector to remove the blind spot monitor buzzer.



b.
E357018

for RHD:

i.

Using a clip remover, disengage the clamp.


ii.

Disconnect the connector to remove the blind spot monitor buzzer.