Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
75720
1.INSTALL FRONT DOOR BELT MOULDING ASSEMBLY
|
Install in this Direction |
Engage the claws to install a new front door belt moulding assembly as shown in the illustration.
Remove the protective tape.
68102
2.INSTALL FRONT DOOR GLASS SUB-ASSEMBLY
67832
3.INSTALL FRONT DOOR SERVICE HOLE COVER
87940
4.INSTALL OUTER REAR VIEW MIRROR ASSEMBLY
5.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
Click hereGeneral>MAINTENANCE>2ZR-FXE AUXILIARY BATTERY>INSTALLATION
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
6.INITIALIZE POWER WINDOW CONTROL SYSTEM
7.INSPECT POWER WINDOW OPERATION