The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the headlight dimmer switch assembly removal/installation are shown below.
*1: When performing learning using the GTS.
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
84307
1.REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
84650
2.REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY
84140
3.REMOVE HEADLIGHT DIMMER SWITCH ASSEMBLY
|
Remove in this Direction |
Disconnect the connector.
Disengage the claws to remove the headlight dimmer switch assembly as shown in the illustration.