Home › Engine / Hybrid System › CRUISE CONTROL › DRIVING SUPPORT BUZZER (for RHD) › 2016.10–2019.09
RM32K0E _51 Engine / Hybrid System _061336 CRUISE CONTROL _0304636 DRIVING SUPPORT BUZZER(for RHD) A

CRUISE CONTROL  DRIVING SUPPORT BUZZER(for RHD)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the driving support buzzer (pre-collision city buzzer) removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point
·

Lane departure alert system (w/ Steering Control)

·

Simple intelligent parking assist system*1

·

Toyota parking assist sensor system*1

·

Pre-collision system


(Click here)
Initialize back door lock Power door lock control system (Click here)


PROCEDURE

Hide 55670A 1.REMOVE INSTRUMENT PANEL CENTER REGISTER ASSEMBLY

Hide 86120 2.REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET (for Radio Receiver Type)

Hide 55521C 3.REMOVE STEREO OPENING COVER WITH BRACKET (w/ Cover)

Hide 86140A 4.REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (for Radio and Display Type)

Hide 55085 5.REMOVE NO. 2 HEATER TO REGISTER DUCT SUB-ASSEMBLY

Hide 86652E 6.REMOVE DRIVING SUPPORT BUZZER (PRE-COLLISION CITY BUZZER)

a.
E357140

Disengage the clamp.


b.

Disconnect the connector to remove the driving support buzzer (pre-collision city buzzer).

NOTICE:

If the driving support buzzer (pre-collision city buzzer) has been struck or dropped, replace it with a new one.