The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the ion generator removal/installation are shown below.
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
After the power switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal (for Audio and Visual System).
After the power switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal (for Navigation System (for Radio and Display Type)).
Use the same procedure for RHD and LHD vehicles.
The following procedure is for the LHD vehicles.
55401E
1.REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
55084E
2.REMOVE NO. 1 HEATER TO REGISTER DUCT SUB-ASSEMBLY
88051A
3.REMOVE ION GENERATOR SUB-ASSEMBLY
Disconnect the connector.
Remove the 2 screws and ion generator sub-assembly with No. 1 ion generator bracket.
Remove the 2 screws, ion generator sub-assembly and air duct sub-assembly from the No. 1 ion generator bracket.