Home › Engine / Hybrid System › M20A-FXS (LUBRICATION) › ENGINE OIL COOLER › from 2019.09
RM32K0E _51 Engine / Hybrid System _083956 M20A-FXS LUBRICATION _0404358 ENGINE OIL COOLER A

M20A-FXS LUBRICATION  ENGINE OIL COOLER  REMOVAL  


PROCEDURE

Hide 51410 1.REMOVE NO.1 ENGINE UNDER COVER ASSEMBLY

Hide 15710 4.REMOVE OIL COOLER ASSEMBLY

a.
A434086C02
0.74,1.208 1.198,1.208 true 2.24,1.521 2.698,1.521 true 0.583,1.125 0.771,1.365 0.188,0.24 10 true *1 2.75,1.427 3,1.635 0.25,0.208 10 true *2
*1 No. 1 Water By-pass Hose
*2 No. 2 Water By-pass Hose


Slide the 2 clips and disconnect the No. 1 water by-pass hose and No. 2 water by-pass hose from the oil cooler assembly.


b.
A434087

Remove the bolt, 2 nuts and oil cooler assembly from the cylinder block sub-assembly.


c.
A426833

Remove the 2 oil cooler gaskets from the oil cooler assembly.


d.
A434088

Remove the oil control valve filter from the cylinder block sub-assembly.