The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during hybrid battery terminal block removal/installation are shown below.
Orange wire harnesses and connectors indicate high-voltage circuits. To prevent electric shock, always follow the procedure described in the repair manual.
To prevent electric shock, wear insulated gloves when working on wire harnesses and components of the high voltage system.
1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
G3834
2.REMOVE SERVICE PLUG GRIP
82121
3.DISCONNECT ENGINE WIRE
4.REMOVE CONNECTOR COVER ASSEMBLY
5.CHECK TERMINAL VOLTAGE
6.INSTALL CONNECTOR COVER ASSEMBLY
82121
7.CONNECT ENGINE WIRE
8.REMOVE BENCH TYPE REAR SEAT CUSHION ASSEMBLY
72693
9.REMOVE REAR SEAT CUSHION LOCK HOOK
67918A
10.REMOVE REAR DOOR SCUFF PLATE LH
76974F
11.REMOVE REAR UNDER SIDE COVER LH
67917A
12.REMOVE REAR DOOR SCUFF PLATE RH
Use the same procedure as for the LH side.
76973F
13.REMOVE REAR UNDER SIDE COVER RH
Use the same procedure as for the LH side.
76971G
14.REMOVE REAR UNDER COVER
71033
15.REMOVE REAR SEAT CUSHION LEG SUB-ASSEMBLY
G92N4A
16.REMOVE NO. 1 HV BATTERY COVER PANEL RH
821H1
17.DISCONNECT HV FLOOR UNDER WIRE
82161
18.DISCONNECT FLOOR WIRE
G92PF
19.REMOVE NO. 4 HV BATTERY PROTECTOR
G920L
20.REMOVE UPPER NO. 1 HYBRID BATTERY COVER SUB-ASSEMBLY
G92Z0
21.REMOVE HV BATTERY JUNCTION BLOCK ASSEMBLY WITH NO. 2 HYBRID BATTERY SHIELD SUB-ASSEMBLY
Be sure to wear insulated gloves and protective goggles.
Disengage the 2 claws and open the wiring harness protector.
Disconnect the HV battery junction block assembly connector.
Insulate the disconnected high-voltage connector with insulating tape.
Disconnect the hybrid battery terminal block connector.
Insulate the disconnected high-voltage connector with insulating tape.
Disconnect the 2 HV battery junction block assembly connectors.
Insulate the disconnected high-voltage connectors with insulating tape.
Remove the bolt, 2 nuts, HV battery junction block assembly and No. 2 hybrid battery shield sub-assembly from the HV battery.
If the HV battery junction block assembly has been struck or dropped, replace it with a new one.
G92Z2
22.REMOVE HYBRID BATTERY TERMINAL BLOCK
Be sure to wear insulated gloves and protective goggles.
Disconnect the hybrid battery terminal block connector.
Insulate the disconnected high-voltage connector with insulating tape.
Disengage the claw to remove the hybrid battery terminal block from the HV battery.