Home › Power Source / Network › POWER DISTRIBUTION › INTEGRATION RELAY › 2019.09–2020.08
RM32K0E _57 Power Source / Network _061291 POWER DISTRIBUTION _0299565 INTEGRATION RELAY A

POWER DISTRIBUTION  INTEGRATION RELAY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the No. 1 integration relay removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: When performing learning using the GTS.

Click here(Click here)

Disconnect cable from negative auxiliary battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Toyota parking assist-sensor system*1
Parking support brake system*1
Simple intelligent parking assist system*1
Pre-collision system
Memorize steering angle neutral point Panoramic view monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)

PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 82662A 3.REMOVE NO. 1 RELAY BLOCK COVER

a.
E353732C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the claws to remove the No. 1 relay block cover as shown in the illustration.


Hide 82641 4.REMOVE NO. 1 INTEGRATION RELAY

a.
E353736C01
1.333,1.833 1.75,1.625 true 1.135,1.729 1.302,1.896 0.167,0.167 10 true *a
*a Protective Tape
V113147

Remove in this Direction


Using a screwdriver with its tip wrapped in protective tape, disengage the claws.


b.

Pull up the No. 1 integration relay as shown in the illustration.

NOTICE:

When pulling the No. 1 integration relay, take care not to damage it.



c.
E353738

Disconnect the 2 connectors to remove the No. 1 integration relay.

NOTICE:

When pulling the No. 1 integration relay, take care not to damage it.