1.INSTALL HV BATTERY JUNCTION BLOCK ASSEMBLY
Be sure to wear insulated gloves and protective goggles.
Install the HV battery junction block assembly to the No. 1 hybrid battery shield sub-assembly with the 4 nuts.
If the HV battery junction block assembly has been struck or dropped, replace it with a new one.
Connect the HV battery junction block assembly connector.
Make sure that the connectors are connected securely.
Engage the 2 claws to install the wiring harness protector.
Connect the HV battery junction block assembly connector.
Make sure that the connectors are connected securely.
Engage the 2 claws to close the wiring harness protector.
Engage the clamp.
Connect the HV battery junction block assembly connector.
Make sure that the connectors are connected securely.
Connect the electric vehicle battery plug assembly with the bolt.
G92J5
2.INSTALL NO. 1 HYBRID BATTERY PACKING
G920L
3.INSTALL UPPER NO. 1 HYBRID BATTERY COVER SUB-ASSEMBLY
82161
4.CONNECT FLOOR WIRE
G92PC
5.INSTALL NO. 1 HV BATTERY PROTECTOR
82161
6.CONNECT FLOOR WIRE
821H1
7.CONNECT HV FLOOR UNDER WIRE
G92N4A
8.INSTALL NO. 1 HV BATTERY COVER PANEL RH
G9230
9.INSTALL BATTERY COOLING BLOWER ASSEMBLY
71033
10.INSTALL REAR SEAT CUSHION LEG SUB-ASSEMBLY
76971G
11.INSTALL REAR UNDER COVER
76974F
12.INSTALL REAR UNDER SIDE COVER LH
67918A
13.INSTALL REAR DOOR SCUFF PLATE LH
76973F
14.INSTALL REAR UNDER SIDE COVER RH
Use the same procedure as for the LH side.
67917A
15.INSTALL REAR DOOR SCUFF PLATE RH
Use the same procedure as for the LH side.
72693
16.INSTALL REAR SEAT CUSHION LOCK HOOK
17.INSTALL BENCH TYPE REAR SEAT CUSHION ASSEMBLY
73350C
18.CONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY
G3834
19.INSTALL SERVICE PLUG GRIP