The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the antenna divider removal/installation are shown below.
After the power switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
55401E
1.REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
55950G
2.REMOVE DEFROSTER NOZZLE ASSEMBLY
86681C
3.REMOVE ANTENNA DIVIDER
Remove the screw.
Disengage the guide to remove the antenna divider.