Home › Drivetrain › P711 (HYBRID TRANSMISSION / TRANSAXLE) › HYBRID TRANSAXLE SYSTEM › from 2019.09
RM32K0E _52 Drivetrain _084042 P711 HYBRID TRANSMISSION / TRANSAXLE _0404749 HYBRID TRANSAXLE SYSTEM G

P711 HYBRID TRANSMISSION / TRANSAXLE  HYBRID TRANSAXLE SYSTEM  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

CAUTION:
A345137

To prevent injury due to contact with an operating V-ribbed belt or cooling fan, keep your hands and clothing away from the V-ribbed belt and cooling fans when working in the engine compartment with the engine running or the power switch on (IG).


PROCEDURE

Hide 51410 1.REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY

Hide 51444A 2.REMOVE REAR ENGINE UNDER COVER LH

Hide 3.INSPECT TRANSAXLE FLUID PRESSURE

NOTICE:

Make sure to perform the following inspection after inspecting and adjusting the engine.


a.
C406245

Remove the transmission oil pump cover plug from the hybrid vehicle transaxle assembly.


b.

Remove the O-ring from the transmission oil pump cover plug.


c.
C406246C03
2.323,0.406 2.719,0.406 2.719,0.406 2.719,0.76 false 2.5,0.771 2.5,0.406 false 2.906,0.813 2.969,0.625 2.969,0.625 3.083,0.625 false 2.167,0.344 2.448,0.573 0.281,0.229 10 false *1 3.125,0.552 3.344,0.75 0.219,0.198 10 false *2
*1 Gasket
*2 O-ring


Install SST to the hybrid vehicle transaxle assembly.

SST
09993-19015  (09993-00020, 09993-00040)


d.

Put the engine in Inspection Mode (Maintenance Mode).

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INSPECTION MODE PROCEDURE


e.

Measure the hybrid transaxle fluid pressure.

Reference:
Maintenance Mode Engine Idle Speed Hybrid Transaxle Fluid Temperature Hybrid Transaxle Fluid Pressure
1050 to 1150 rpm 20 to 50°C (68 to 122°F) 9.8 kPa (0.1 kgf/cm2, 1 psi) or more


NOTICE:

Be sure to cancel maintenance mode immediately after the hybrid transaxle fluid pressure check is completed.



f.

Remove SST from the hybrid vehicle transaxle assembly.


g.

Coat a new O-ring with ATF and install it to transmission oil pump cover plug.


h.

Install the transmission oil pump cover plug to the hybrid vehicle transaxle assembly.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


Hide 51444A 4.INSTALL REAR ENGINE UNDER COVER LH

Hide 51410 5.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY