1.SECURE VEHICLE
Fully apply the parking brake and chock a wheel.
Make sure to apply the parking brake and chock a wheel before performing this procedure.
If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.
51410
2.REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY
17410
3.REMOVE FRONT EXHAUST PIPE ASSEMBLY
58151
4.REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
Remove 3 nuts and front No. 1 floor heat insulator from the vehicle body.
33504F
5.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
6.REMOVE REAR CONSOLE BOX ASSEMBLY
33820B
7.REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY
Move the shift lever to N.
|
Remove in this Direction |
Disconnect the transmission control cable assembly from the transmission floor shift assembly.
| *1 | Slider |
|
Push |
|
Remove in this Direction |
Push in the slider and remove the transmission control cable from the floor shift shift lever assembly as shown in the illustration.
Remove the nut to disconnect the transmission control cable assembly from the control shaft lever.
Remove the clip to disconnect the transmission control cable assembly from the No. 1 transmission control cable bracket.
Disengage the clamp to separate the fuel tube sub-assembly.
Disengage the clamp to separate the transmission control cable assembly.
Remove the bolt to disconnect the transmission control cable assembly from the hybrid inverter protector assembly.
Remove the nut.
Disengage the guide to disconnect the transmission control cable assembly from the vehicle body.
Remove the 2 nuts and transmission control cable assembly from the vehicle body.
23841G
8.REMOVE FUEL HOSE CLAMP
Perform this procedure only when replacement of the fuel hose clamp is necessary.
Disengage the 2 claws to remove the fuel hose clamp from the transmission control cable assembly.