Home › Engine / Hybrid System › M20A-FXS (ENGINE CONTROL) › ENGINE COOLANT TEMPERATURE SENSOR › from 2019.09
RM32K0E _51 Engine / Hybrid System _083960 M20A-FXS ENGINE CONTROL _0404841 ENGINE COOLANT TEMPERATURE SENSOR A

M20A-FXS ENGINE CONTROL  ENGINE COOLANT TEMPERATURE SENSOR  INSTALLATION  


PROCEDURE

Hide 89422A 1.INSTALL ENGINE COOLANT TEMPERATURE SENSOR

HINT:

Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.

Click hereEngine / Hybrid System>M20A-FXS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION


a.
A427575

Apply a light coat of engine coolant to the O-ring of the engine coolant temperature sensor.


b.

Install the engine coolant temperature sensor to the water by-pass outlet with a new clip.

NOTICE:
·

If the engine coolant temperature sensor has been struck or dropped, replace it.

·

If reusing the engine coolant temperature sensor, be sure to inspect the O-ring.

·

Make sure that the O-ring is not cracked or moved out of place when installing the engine coolant temperature sensor.




c.

Connect the engine coolant temperature sensor connector.


Hide 3.ADD ENGINE COOLANT (for Engine)

Hide 4.INSPECT FOR COOLANT LEAK (for Engine)

Hide 51444A 5.INSTALL ENGINE UNDER COVER REAR LH

Hide 6.PERFORM INITIALIZATION

a.

Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.

Click hereEngine / Hybrid System>M20A-FXS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION