Home › Engine / Hybrid System › M20A-FXS (ENGINE CONTROL) › ENGINE COOLANT TEMPERATURE SENSOR › 2019.09–2020.08
RM32K0E _51 Engine / Hybrid System _083960 M20A-FXS ENGINE CONTROL _0404841 ENGINE COOLANT TEMPERATURE SENSOR A

M20A-FXS ENGINE CONTROL  ENGINE COOLANT TEMPERATURE SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during engine coolant temperature sensor or No. 2 engine coolant temperature sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: When performing learning using the GTS.

Click here(Click here)

Auxiliary battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Toyota parking assist-sensor system*1
Parking support brake system*1
Simple intelligent parking assist system*1
Pre-collision system
Memorize steering angle neutral point Panoramic view monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)
Replacement of inverter with converter assembly Resolver learning
·

DTCs are stored

·

Slight vibration at a vehicle speed of 5 km/h (3 mph) or less

·

Shock or vibration during acceleration


(Click here)
for M20A-FXS

Replacement of engine coolant temperature sensor


Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)
for M20A-FXS

ECM


Perform Vehicle Identification Number (VIN) registration MIL comes on (Click here)

PROCEDURE

Hide 51444A 1.REMOVE REAR ENGINE UNDER COVER LH

Hide 2.DRAIN ENGINE COOLANT (for Engine)

Hide G9200 3.REMOVE INVERTER WITH CONVERTER ASSEMBLY

Hide 89422A 4.REMOVE ENGINE COOLANT TEMPERATURE SENSOR

a.
A433111

Disconnect the engine coolant temperature sensor connector.


b.
A433112

Remove the clip and engine coolant temperature sensor from the water by-pass outlet.

NOTICE:

If the engine coolant temperature sensor has been struck or dropped, replace it.